How to Charge
Back to Normal VersionBack to Normal Version 
 
Preceding Page In Manual:

"Controller"Page 21Next Page In Manual:

"Charging Phases"

Alert
The Sparrow is equipped with a drive/charge interlock. This is a relay that disables the Sparrow's start circuit while the car is on charge. The drive/charge interlock prevents driving the car away while the cord is plugged in.
Step 1
WARNING: Do not plug your Sparrow into a 220-volt outlet if it has a 110-volt charger. The charger can be damaged.
Recharge your Sparrow by parking your vehicle within 10 feet of a 110-volt or 220-volt electrical outlet, whichever corresponds to the voltage that is stated on the battery charger nameplate.
Related Page:
Charger
Step 2
Click for larger imageClick for larger image
The charging receptacle on the Sparrow is located on the right side of the vehicle, in front of the door and above the fender.

It looks like an ordinary gas cap

Click for larger imageClick for larger image
Open the charging receptacle by pushing on the right edge of the access cover to the receptacle.
Step 3
Click for larger imageClick for larger image
Align the charging cord connector pins with the corresponding receptacle pins.
Step 4
Click for larger imageClick for larger image
When properly aligned, push in on the connector and turn counterclockwise until the connector locks into the receptacle.
Step 5
Plug the other end of the charging cord into a grounded 3 prong receptacle.
NOTE:Check your Sparrow 30 minutes after plugging into the electrical outlet to ensure that it is still charging and that the circuit has not tripped.

Check for newer version of this manual


 Related Pages
Charger