Charger
Printer-Friendly VersionPrinter-Friendly Version 
 
Preceding Page In Manual:

"Brush Motor"Page 19Next Page In Manual:

"Controller"

Determining Charger Voltage
WARNING: Do not plug your Sparrow into a 220-volt outlet if it has a 110-volt charger. The charger can be damaged.
The battery charger is installed under the front hood of your Sparrow. Since it is permanently on board, you can plug into any 110-volt or 220-volt outlet, depending on what voltage charger your Sparrow is equipped with, to recharge your Sparrow. Most Sparrows are equipped with a 110-volt battery charger as standard equipment.
Knowing your charger's voltage is crucial. A sticker located near the charger's power cord will indicate whether you have a 110 volt or 220 volt charger.
Related Page:
How to Charge
Related Page:
Charging Phases

Check for newer version of this manual


 Related Pages
How to Charge
Charging Phases