Heater/Fan and Vents
Printer-Friendly VersionPrinter-Friendly Version 
 
Preceding Page In Manual:

"Four-way Safety Lights"Page 31Next Page In Manual:

"High Beam Switch"

Heating, Cooling and Defrosting
NOTE:Power up your Sparrow before turning on the fan and heater to avoid a short circuit and fuse blowout caused by drawing excessive current.
The two red / orange toggle switches on the left side of the dashboard control the heater and fan. Turn on the fan by pushing the left button. Turn on the heater by pushing the right button. You can operate the fan only, but you must first turn on the fan (left button) to operate the heater (right button).

The three louvered vents provide cooling or heat for the driver's compartment and defrosting of the windshield. Control the heater and defroster by manually adjusting (open / close and left / right positioning) the vent louvers.

Power up your Sparrow before turning on the fan or heater. (The controller must be on and the green enable light illuminated.) Always turn off the vent fan and the heater before exiting your Sparrow. The tops of both red / orange buttons should be pushed in for the Off position.

Check for newer version of this manual